Description

RonaScreed FastDry Prompt screeding additive for site batched screeds is used to quickly reduce the level of retained moisture within the screed allowing floor coverings to be laid over the screed much sooner than with conventional screeds. RonaScreed FastDry Prompt gains strength quickly, permitting early access by following trades.

RonaScreed FastDry Prompt is supplied in concentrated form and used in low dilution. It promotes rapid drying and early laying of floor coverings such as sheet vinyl, tiles and other materials including the range of RonaFloor Epoxy and Polyurethane coatings (refer to Ronacrete Technical Department).

RonaScreed FastDry Prompt is typically incorporated within 35mm to 100mm thick floor screeds and applied by competent screeding contractors. RonaScreed FastDry Prompt is simple and straightforward to use and can be purchased and laid by non-licensed screeding contractors.

Features

• Will accept foot traffic after 24 hours @ 200C
• Rapid drying—can receive floor coverings such as vinyl, tiles and carpet after 8 days @ 50mm, 9 days at 75mm and 10 days @ 100mm thick
• Rapid early strength development
• Liquid admixture disperses quickly and fully in the gauging liquid
• Apply as a bonded screed from 35mm, unbonded from 50mm and floating from 65mm
• Compatible with underfloor heating
• Compressive strength in excess of 40N/mm² can be achieved after 28 days, see mix design
• Suitable for screed pumps
• Concentrated admixture saves packaging waste